Finished up a breadboard of some crossovers for a pair of Tannoy 15" Reds. Added a bit of ajustability and the coolest thing was how the sims and the measured responses matched each other. The nasty technical bits can be seen here.
Going to give them a listen tomorrow but for now I'll leave you with a picture of the beasts which will be confirmed for sonics and inserted into a nice wood box.
Just for a tease, These are the simmed and measured of the 3K notch filter, top line is without it and then it slowly get introduced.
The other “Trout Mask Replica” 💫
-
This would/could have been Capt. Beefheart’s “Trout Mask Replica” cover…
Artwork was rejected by Don Van Vliet, who choose the famous one…
💫
19 minutes ago
Beautiful looking circuits, DS.
ReplyDeleteWill watch for next installment.
For laughs, you might check out my kitchen cabinet site over at http://home.earthlink.net/~vaporetto/
...
Where, in direct contrast to your efforts, we adamantly make everything up as we go along.
Can't wait to hear your analysis of the sound with new crossovers.....
rgds, The Torsion People
If only you could have sourced a heavier-duty switch!
ReplyDelete